> ## Knowledge Base Index
> Fetch the complete knowledge base index at: https://support.indusuite.com/sitemap.xml
> Use this file to discover available pages before exploring further.
> Pure-Markdown content can be obtained by appending a '.md' suffix to the content URLs listed in the sitemap (without the trailing slash).

# How to change Wi-Fi network configuration for Universal Connector

# Change Universal Connector Wi-Fi settings with WeldCloud Link app

This tutorial guides you through updating the Wi-Fi configuration of your Universal Connector.
You’ll need to do this if you change your Wi-Fi password or want to connect to a different network.

**Prerequisite:** An Android device with the *WeldCloud Link* app installed (available on the Google Play Store).
For detailed instructions on downloading the app, please refer to this [article](https://support.indusuite.com/en/article/getting-started-with-weldcloud-link-app-185w9b6/).

The steps below explain how to update the Wi-Fi settings on your Universal Connector.

**1.** Open **WeldCloud Link** app

**2.** Click **SKIP**

**3.** Click on the **hamburger menu** on the top left of the app

**4.** Click **Welding Unit Setup**

**5.** Click **CONNECT**

**6.** WeldCloud Link will scan for nearby devices

![WeldCloud Link will scan for nearby devices](https://storage.crisp.chat/users/helpdesk/website/-/1/c/b/d/1cbda94eeb4b4100/step06_1a6vdv4.webp)

**7.** Tap on the Universal Connector you want to change network configuration

![Tap on the Universal Connector you want to change network configuration](https://storage.crisp.chat/users/helpdesk/website/-/1/c/b/d/1cbda94eeb4b4100/step07_171273n.webp)

**8.** Click on **PAIR**

**9.** A check mark will show once pairing is complete

![A check mark will show once pairing is complete](https://storage.crisp.chat/users/helpdesk/website/-/1/c/b/d/1cbda94eeb4b4100/step09_1iurfdo.webp)

**10.** Click **NETWORK SETTINGS**

**11.** Enter password you set first time you configured the Universal Connector and click **LOG IN**

**12.** Click **Wifi**

**13.** Click on the wifi icon to scan for available networks

**14.** Tap on the wifi network you want to connect

**15.** Fill in wifi network password and click **SAVE CHANGES**

**16.** WeldCloud Link will show a message confirming the operation

![WeldCloud Link will show a message confirming the operation](https://storage.crisp.chat/users/helpdesk/website/-/1/c/b/d/1cbda94eeb4b4100/step16_fopvxi.webp)

**17.** Click on the go back arrow at the top left of the app

**18.** Wait until both Wifi and WeldCloud icon are enabled again

![Wait until both Wifi and WeldCloud icon are enabled again](https://storage.crisp.chat/users/helpdesk/website/-/1/c/b/d/1cbda94eeb4b4100/step18_hvtmyu.webp)