How to connect ESAB EDGE system to WeldCloud using gateway web interface

Connect via Wi-Fi

Step-by-step walkthrough for connecting an ESAB Warrior EDGE system to WeldCloud by accessing the gateway's web configuration page over Ethernet and configuring WiFi connectivity. 12 steps.

Prerequisites

• ESAB Warrior EDGE system
• WiFi USB dongle installed (see How to connect Bluetooth and WiFi dongles to Warrior EDGE and Supported connectivity dongles)
• PC with Ethernet port and Ethernet cable
• Asset pre-created in WeldCloud with configuration file downloaded
• Active InduSuite account with WeldCloud license
• At least one Site created in WeldCloud

Procedure

1. Turn on welding equipment and wait 2 minutes for gateway to boot
2. Connect your PC and welding equipment through Ethernet cable

   
   

   
   
3. Open browser and navigate to esab.local:8080 (or esab.local:8443 (HTTPS) for EDGE software package LP14 and later)
4. Enter credentials and click "Login" — default username: admin, password: gateway

   
   

   
   
5. You will be forced to change the default gateway password — choose your password and fill in twice, then click "Save new password"

   
   

   
   
6. Click "Configuration"

   
   

   
   
7. Click to open Wi-Fi details

   
   

   
   
8. Pick your wireless network, type the password, and click "Connect"

   
   

   
   
9. Check Wi-Fi network connection status on the gateway page

   
   

   
   
10. Click "WeldCloud configuration"

11. Click on "Browse" button and load the configuration file downloaded previously

12. Click "Save changes"

13. Check WeldCloud connectivity status

Connect via wired connection

Step-by-step walkthrough for connecting an ESAB Warrior EDGE system to WeldCloud by accessing the gateway's web configuration page over Ethernet and configuring wired network connectivity. 12 steps.

Prerequisites

• ESAB Warrior EDGE system
• PC with Ethernet port and Ethernet cable
• Asset pre-created in WeldCloud with configuration file downloaded
• Active InduSuite account with WeldCloud license
• At least one Site created in WeldCloud

Procedure

1. Turn on welding equipment and wait 2 minutes for gateway to boot
2. Connect your PC and welding equipment through Ethernet cable

   
   

   
   
3. Open browser and navigate to esab.local:8080 (or esab.local:8443 (HTTPS) for EDGE software package LP14 and later)
4. Enter credentials and click "Login" — default username: admin, password: gateway

   
   

   
   
5. You will be forced to change the default gateway password — choose your password and fill in twice, then click "Save new password"

   
   

   
   
6. Click "Configuration"

   
   

   
   
7. Click to expand wired configuration settings

   
   

   
   
8. Select IP assignment — use Dynamic (DHCP) for most network environments

   
   

   
   
9. Click "Save changes"

   
   

   
   
10. Click "WeldCloud configuration"

11. Click on "Browse" button and load the configuration file downloaded previously

12. Click "Save changes"

13. Disconnect your laptop from the EDGE and connect the EDGE to your wired network

Updated on: 17/07/2026